X12SHDSL-V2 option card test
Overview
This test verifies that the X12SHDSL-V2 option card is properly installed and that it
functions correctly. In case of a DDF, the correct DDF labeling is checked by means of
port alarming.
Estimated duration
12 minutes
Remarks
For this test, an SHDSL E1 Modem (TU12/E1) is required. Do not connect it until asked
in the procedure.
SHDSL is the same as SDSL. SHDSL refers to the ITU-T standard and SDSL refers to
the ETSI standard.
Test setup
The following figure illustrates a possible test setup:
ote:
For a long haul laser (L12 or L42), a 10 dB attenuator with applicable
connector is required in the loop.
Start condition
Ensure that the following start condition is fulfilled:
•
The procedure in section
“Preparation and test of the main unit” (p. 7-4)
must have
been performed and the test results are correct.
•
X12SHDSL-V2 option card is installed.
•
the ITM-CIT is connected and logged-in to the E
Figure 7-5 X12SHDSL-V2 option card test
Stand-alone test procedures
X12SHDSL-V2 option card test
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
365-313-103R8.0
Issue 2
July 2009
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
7-21
