Stripping and connecting a low frequency cable
Proceed as follows to strip and connect a low frequency cable:
...................................................................................................................................................................................................
1
Follow the steps sequentially as shown in the figure below to perform this procedure.
Legend:
*1
The maximum power of the soldering iron is 50 W. If the temperature
is adjustable, it should be adjusted to a maximum of 350°.
E
N D
O F
S T E P S
...................................................................................................................................................................................................
Figure C-2 Low frequency cable
Cable assembly instructions
SUB-D connector
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
C-4
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
365-313-103R8.0
Issue 2
July 2009