•
Work in an area which is protected against electrostatic discharge. Use conducting
floor and bench mats which are conductively connected to an ESP bonding point.
•
Conductively connect all test equipment and trolleys to an ESP bonding point.
•
Store and ship the option cards/SFPs in their shipping packing. The option cards/SFPs
must be packed and unpacked only at workplaces suitably protected against build-up
of charge.
•
Whenever possible, maintain the relative humidity of air above 20%.
ITM-CIT requirements
Requirements
For the ITM-CIT a personal computer is necessary which fulfils the following minimum
requirements:
•
Pentium
®
processor with 450 MHz or higher
•
128 MB RAM or higher
•
Keyboard
•
Mouse
•
300 MB of free hard-disk drive space
•
CD-ROM drive
•
Display with 1024 × 768, 16 million colors recommended
•
RS-232 communication port (serial asynchronous port)
•
Microsoft
®
Windows
®
2000 or
Windows XP
®
operating system
•
ITM-CIT connector (F-interface) cable (one end RS-232 and the other end RJ-45
modular jack), CC848069795.
The performance can be enhanced by using a higher performance personal computer.
Independent of the requirements listed above the minimum requirements of the operating
system must be fulfilled. A CD-ROM containing the ITM-CIT software must be
available.
General information
EMC/ESD information
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
2-10
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
365-313-103R8.0
Issue 2
July 2009
