Required tools and test equipment
Tools
A variety of tools is required to carry out the installation procedures. The following table
provides an overview of the required tools.
Table 2-4
Required tools
Quantity
Description
Comments
1
Metric tool set
to be used for physical installation
1
Torque wrench
to be used when tightening the AMC units to the
rackframe
1
ESD wrist strap
to be worn when handling option boards and SFPs
1
Soldering iron
to be used for soldering cables
1
RJ45 crimping tool
to be used for terminating RJ45 cables
1
1.6/5.6 coax crimping tool
to be used for terminating 1.6/5.6 coax cables
1
PC (Laptop)
to be used for E provisioning via ITM-CIT
Isopropanol, compressed air and
wipes
to be used for fiber cleaning
Test equipment
A variety of test equipment is required to carry out the individual tests. The following
table provides an overview of the required test equipment.
Table 2-5
Required test equipment
Quantity
Description
Comments
1
SDH Analyser
(STM-1/STM-4)
to be used for performing some installation tests
1
Optical power meter
to be used for measuring the optical output power
1
Multimeter
to be used for measuring power supplies
1
Adjustable optical attenuator
to be used for measuring the receiver sensitivity.
A 15 dB LBO must be used for optical test loops or for
testing the individual ports.
General information
Required tools and test equipment
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
365-313-103R8.0
Issue 2
July 2009
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
2-11