ITM-CIT interface
Purpose
This interface must be used for connecting a local ITM-CIT management system.
Connector data
The ITM-CIT connector is an 8-pin RJ45 connector with metal shell for grounding.
Table 4-9
Pin assignment (ITM-CIT cable)
Point on Connector
Signal Name
Description
1
nc
ot connected
2
CTS_CIT
Clear To Send
3
GRD
Ground
4
TxD
Transmitted Data
5
RxD
Received Data
6
RTS
Request To Send
7
DTR
Data Terminal Ready
8
nc
ot connected
Cable connection
Please connect the ITM-CIT cable as shown in the figure below.
Figure 4-17 ITM-CIT connector
1
8
Figure 4-18 ITM-CIT cable
System cabling
External cable installation
ITM-CIT interface
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
365-313-103R8.0
Issue 2
July 2009
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
4-19