ote:
The routing of the ITM-CIT cable should be in accordance with the
recommended practices of the cable selected. The cable should be strain relieved to
prevent any force from being exerted on the connectors.
Orderable cable
An ITM-CIT cable with a length of 1.5 m [4.921 ft] can be ordered (CC848069795).
ote:
A standard RS232 cable can also be used.
EOW interfaces
Purpose
An Engineering Order Wire (EOW) can be connected to these interfaces.
ote:
The EOW interfaces are only available on 1645 AMC units.
Connector data
The 1 × E1/E2/F1 EOW connectors are 15-pin SUB-D male connectors (hot shrinked,
tailed). They provide V.11 data channels with a bit rate of 64 kbit/s.
Table 4-10
Pin assignment (EOW cables, valid for both connectors)
Point on connector
Signal name
1
GD
2
V11RCP
Figure 4-19 ITM-CIT cable connection
Figure 4-20 EOW connector
1
9
8
15
System cabling
External cable installation
ITM-CIT interface
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
4-20
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
365-313-103R8.0
Issue 2
July 2009
