Conclusion:
If the Fault LED is OFF, then the option card is accepted and the option
card software is correctly loaded. If the Link LED comes on and the alarms are
reported, then the option card is correctly installed.
...................................................................................................................................................................................................
5
If a DDF is applicable, then proceed with
. If no DDF is applicable, then proceed
with
...................................................................................................................................................................................................
6
Connect LA2.1 to LA2.3.
...................................................................................................................................................................................................
7
Check on the alarm list, and verify that the requirements mentioned in the table below are
met.
Result:
Requirements
Link LEDs of related LA ports:
On (green)
Alarms reported on the ITM-CIT:
“LAcES” reported on LA2.1 and
LA2.3
Conclusion:
Results of
and
prove that the DDF labeling of LA2.1,
LA2.2, and LA2.3 is correct.
...................................................................................................................................................................................................
8
Connect LA2.1 to the next LA port.
...................................................................................................................................................................................................
9
Check on the alarm list, and verify that the requirements mentioned in the table below are
met.
Result:
Requirements
Link LEDs of related LA ports:
On (green)
Alarms reported on the ITM-CIT:
“LAcES” reported on related LA
...................................................................................................................................................................................................
10
Repeat
and
for all other LA ports.
...................................................................................................................................................................................................
11
Disconnect the LA cable from the LA ports. Wait until all LAcES alarms have
cleared.
...................................................................................................................................................................................................
12
Insert a GbE SFP in the SFP slot of the X5IP.
Stand-alone test procedures
X8PL and X5IP option card test
...................................................................................................................................................................................................................................
...................................................................................................................................................................................................................................
365-313-103R8.0
Issue 2
July 2009
Alcatel-Lucent – Internal
Proprietary – Use pursuant to Company instruction
7-19
