8AL90320ENABed01
23 /33
3.3
Sending a calibrated cut-off or flash
This feature sends a calibrated cut-off or flash on the line before sending dialed digits in transparency
mode.
Pressing the
Flash
softkey sends a calibrated pulse to the remote piece equipment. This remote
equipment can then return a tone inviting the attendant to continue dialing.
3.4
Temporary hold of automatic transfer
If the automatic transfer mode is activated, the current call is automatically transferred to a free user
after the attendant has dialed the user number.
The feature is enabled when the checkbox next to the feature label is validated.
1.
When receiving an external call while the Automatic transfer is enabled, deactivate
temporarily the automatic transfer by pressing on the softkey:
Transfer off.
3.5
Directory number supervision
The attendant may supervise several internal numbers when the Directory Number Supervision
feature
is programmed by the system administrator for these internal numbers.
These internals sets must be in the same node as the attendant set.
When supervised internal number is displayed in the
main (perso)
page, the name of the
corresponding user is followed by an icon indicating their set state:
Indicates that the internal user is busy.
(flashing) Indicates that the internal user is on hold.
Indicates that the internal user has left a callback request or is in conversation with the
attendant set.
Indicates that the internal user has requested an urgent conversation with the attendant set.
When supervised internal number is displayed on a Smart Display Module, the name of the
corresponding user is followed by an icon indicating their set state
Indicates that the internal user is busy.
Indicates that the internal user has left a callback request or is in conversation with the
attendant set.
Indicates that the internal user has requested an urgent conversation with the attendant set.
(flashing) Indicates that the internal user is on hold.
