Getting to know your telephone
8AL90339ENADed01
39 /119
Installing or replacing the Bluetooth® handset battery
At the first use, you have to connect the battery to the handset. The battery is placed in its compartment
but it is not connected. To install a new battery, follow instruction:
a) Lift up the battery cover.
b) Take the 2 connectors.
c) Assemble the 2 connectors.
d) Arrange the battery, the cable and the
connectors in the battery compartment
(place the connected side of the battery in
the bottom of the compartment)
e) Slide out the battery holding part.
f) Replace the cover.
The battery recharges when the Bluetooth® handset is on its base.
Switch on / off the Bluetooth® handset: long press on the off-hook/on-hook key.
Defective batteries must be returned to a collection point for chemical waste disposal.
Pairing and connecting the Bluetooth® wireless handset
This feature is only available with compatible Bluetooth® desk phone. Otherwise the corresponding
menu is not displayed or is inactive.
1- Set your desk phone to 'discover' the Bluetooth® wireless handset
•
Use one of the following:
o
o
(long press)
Bluetooth
•
Search devices
2-
Put the handset in detectable mode
•
Keeping the handset turned off, press and hold the 2 Bluetooth® handset keys (B, C) at
the same time. You will hear a 3 note signal and the LED will flash green and orange
alternately.
3-
Connect the handset with the desk phone
•
Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed.
•
Select the relevant equipment: ALE BT Handset.
•
Add
•
Enter the PIN code of the device if necessary.
•
Confirm
The 3-note tone indicates that the handset has been installed correctly. The LED
flashes green or orange depending on the battery charge level.
•
Go back to the Homepage.
The handset is correctly connected if it appears in the list of connected devices on your desk phone.
Press the Line key of the handset to test the connection, your desk phone will prompt you to enter a
number.