............................................................................................................................................................................................................................................................
Initial circuit pack installation
Powering and initial circuit pack installation for 1665 Data
Multiplexer (1665 DMX)
2 - 3 4
365-372-304R7.1
Issue 1, November 2007
........................................................................................................................................................................................................................
4
Check off the appropriate box in
Appendix E, “Installation checklist”
.
........................................................................................................................................................
E
N D
O
F
S
T E P S
Install pluggable transmission modules
This section contains the instructions for the installation of the pluggable transmission
modules.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper circuit pack type and the
port socket being equipped with the pluggable module (SFP). Make sure the transmission
rate (OC3, OC12, 100Base Ethernet or GbE) matches the rate of the SFP. See
G, “Pluggable transmission module installation”
.
Important!
Pluggable modules are shipped with a dust plug installed into the ports to
maintain cleanliness during storage and/or transportation. It is recommended that the
dust plug be kept in place to maintain cleanliness. With proper care and handling,
cleaning the pluggable modules should not be necessary.
........................................................................................................................................................................................................................
2
Check the ports for cleanliness and clean the pluggable module if necessary. See
........................................................................................................................................................................................................................
3
Insert the pluggable module in the required socket of the circuit pack faceplate, then
wiggle the module to verify that it is locked in the socket. See
transmission module installation”
. Verify that all unused sockets are equipped with dust
plugs.
........................................................................................................................................................................................................................
4
if more modules need to be installed.
CAUTION
Never mechanically clean the receive (RX) port. Air blows only should be used
on the receive (RX) port. The receive (RX) port contains a lens for focusing a
wide input. The lens is more easily scratched than cleaned.
Summary of Contents for Data Multiplexer Explore 1665
