............................................................................................................................................................................................................................................................
Initial circuit pack installation
Powering and initial circuit pack installation for 1665 Data
Multiplexer (1665 DMX)
2 - 1 2
365-372-304R7.1
Issue 1, November 2007
............................................................................................................................................................................................................................................................
Initial circuit pack installation
Description
This section provides instructions for installing, BUT NOT fully seating, circuit packs into
the 1665 DMX High-Capacity shelf. After circuit packs have been unpacked, they may be
placed in their respective slots in the 1665 DMX High-Capacity shelf but NOT FULLY
ENGAGED IN THE BACKPLANE CONNECTOR. The circuit packs will be fully
installed (seated) in
Chapter 3, “Software download and circuit pack installation”
Important!
If office alarms are connected, it is advisable to disconnect the office
alarm cable while performing the procedures in this section to prevent spurious alarms
from being reported. Reconnect the office alarm cable after completion of all testing.
To protect against damage due to electrostatic discharge, a properly grounded ESD wrist
strap must be worn when handling equipment.
Important!
When only one main OLIU (OC-12, OC-48, OC-192) or main switch
pack (LNW80) is required, it must be installed in the M1 slot.
LNW2 (SYSCTL) installation
Follow this procedure to install the LNW2 (SYSCTL) circuit pack into the 1665 DMX
High-Capacity shelf.
........................................................................................................................................................................................................................
1
Remove the SYSCTL circuit pack from the packing material. Verify that there are two
NVM memory cards.
Important!
Do not remove the NVM cards.
........................................................................................................................................................................................................................
2
Identify the
CTL
slot on the 1665 DMX High-Capacity shelf. See
High-Capacity shelf” (p. 2-11)
CAUTION
Blank circuit packs are required in all unequipped Main slots, Function Unit,
and Growth slots to provide proper air flow for cooling.
CAUTION
ESD hazard
Summary of Contents for Data Multiplexer Explore 1665
