Alcatel-Lucent OAW-AP277, Installation Manual

8

OAW-AP277 Outdoor Access Point

| Installation Guide

Using the AP-270-MNT-H1 Mounting Kit

The OAW-AP277 access point can be installed on a wall or attached to a pole by using AP-270-MNT-

H1 mounting kit.

Mounting the OAW-AP277 Access Point to a Wall

1. Use the mounting template provided in the AP-270-MNT-H1 mounting kit package to mark the 

four mounting points on the wall.

2. Use a drill to create four holes on the four markings you created in the previous step.
3. Insert an anchor bolt into each drilled hole. Anchor bolts are not included in the mounting kit 

package.

4. Place the mounting bracket over the anchor bolts and press the bracket against the wall.
5. Place the washers and nut onto the bolt’s threaded end and tighten the nut until the mounting 

bracket is firmly attached to the wall as shown in 

Figure 6

.

Figure 6  

Attaching the Mounting Bracket to a wall

6. Use the M10x30 screw (with washer) and M10 nut included in the package to attach the mounting 

holder to the mounting bracket as shown in 

Figure 7

. 

The OAW-AP277 access point does not ship with any mounting kit. The AP-270-MNT-H1 mounting kit is 
available as accessories and must be ordered separately.

For details on AP-270-MNT-H1, please refer to the 

AP-270-MNT-H1 Installation Guide

.