16
OAW-AP277 Outdoor Access Point
| Installation Guide
Safety and Regulatory Compliance
Alcatel-Lucent Networks provides a multi-language document that contains country-specific
restrictions and additional safety and regulatory information for all Alcatel-Lucent access points. This
document can be viewed or downloaded from the following location:
http://www.alcatel-lucent.com/
enterprise
Regulatory Model Name
The regulatory model name of OAW-AP277 is APEX0102.
FCC
This device is electronically labeled. To view the FCC ID:
1. Log into the controller WebUI
2. Navigate to
Maintenance > Controller > About
.
FCC Class B Part 15
This device complies with Part 15 of the Federal Communications Commission (FCC) Rules. Operation
is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the manufacturer’s instructions,
may cause interference harmful to radio communications.
If this equipment does cause interference, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio or TV technician for help.
!
CAUTION
Alcatel-Lucent access points must be installed by a professional installer. The professional installer is
responsible for ensuring that grounding is available and it meets applicable local and national electrical codes.
!
CAUTION
RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits. This
equipment should be installed and operated with a minimum distance of 13.78 inches (35 cm) between the
radiator and your body for 2.4 GHz and 5 GHz operations. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. When operated in the 5.15 to 5.25 GHz frequency range,
this device is restricted to indoor use to reduce the potential for harmful interference with co-channel Mobile
Satellite Systems.
!
CAUTION
Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
