The Line Cards
47
Chapter 7
24 FE Ports
These ports are used to connect APs and wired LAN segments to the Alcatel
Wireless LAN Switch. These ports provide 10/100 Mbps Ethernet
connectivity, and in some cases, power and serial connectivity as well. See
page 49
for port and cable specifications.
LNK/ACT LED
Each FE port has its own LNK/ACT LED, located at the left side of the port.
During operation, these LEDs provide the following status information:
POE LED
This LED is supported only on line cards that support POE (such as
OAW-LC-2G24FP) and provides the following POE status information:
T
ABLE
7-1
FE LNK/ACT LED
Status
Description
Off
No Ethernet link on the port.
Green
An Ethernet link has been established on the port, but no
data is currently being transmitted or received.
Flashing
Green
The port is transmitting or receiving data. The flashing
rate is proportional to your network activity.
Amber
The Ethernet link on the port is encountering errors.
T
ABLE
7-2
FE POE LED
Status
Description
Off
The port is disabled or the attached device has not
requested power. POE is not being provided by the port.
Green
POE is being provided to the attached device.
Amber
The attached device has requested power, but POE is not
being provided by the port.
3
A
B
Summary of Contents for OmniAccess 6000
