16/314
3CC08991ATAA TQ BJA 01
Issue 01 -- March 2004
1.3
--
Safety instructions
1.3.1 -- General rules
The following general safety precautions must be observed by the installer and the operator. ALCATEL
assumes no liability for the customer’s failure to comply with these requirements.
Ground the equipment: For Safety Class 1 equipment, always connect the earth conductor of the power cable
to an appropriate earthing device.
DO NOT operate the product in an explosive atmosphere or in presence of flammable gases or fumes.
For protection against fire: replace the line fuse(s) only with fuse(s) of the same voltage and current rating
and type.
Dangerous voltages: Users must not remove equipment covers or shields. The installation and maintenance
procedures described in this manual are for use by service-trained personnel only.
DO NOT operate equipment which may be damaged: Whenever it is possible that the safety protection
features built into this equipment have been impaired, ISOLATE FROM THE POWER SUPPLY and do not use
the equipment until safe operation can be verified by service--trained personnel. If necessary, return the
equipment to Alcatel After Sales for service and repair.
DO NOT substitute parts or modify equipment: Return the product to Alcatel Customer Service for servicing
and repair.
Each main IDU contains a lithium battery to back up data. This battery should be changed every 7 to 10 years,
when inventory memory becomes empty following a power outage (see § 7.15.1).
CAUTION
There is a risk of explosion if the incorrect battery is used.
Only replace with a battery of the same type:
M4T28--BR12SH1, Supplier: STMicroélectronics
Observe all applicable national standards regarding the disposal of used batteries.
Do not burn and do not recharge.
1.3.2 -- Symbols
1.3.2.1 -- Danger symbols
When subsystems and modules have warning labels, it is extremely important to follow their instructions.
These labels are designed to indicate dangerous situations; they may contain any standard symbol or any text
considered necessary to protect users and employees.
The most frequent danger situations and symbols are:
Danger or general warning
!
Prompts the user to refer to the manual.
Dangerous electrical voltages
Close to dangerous voltages (>42.4 V AC peak, 60 V DC; power level >240 VA) you will find
this warning label
Presence of heat-radiating mechanical parts
Summary of Contents for 9400 UX
