73/314
3CC08991ATAA TQ BJA 01
Issue 01 -- March 2004
3.5
--
Outdoor part installation
3.5.1 -- General information
3.5.1.1 -- Pole mounting
The mechanical assembly is supplied complete, mechanically assembled, with screw fastenings kit and ground
terminals included in a plastic bag inside the casting.
The standard mechanical system is mounted on a pipe with a diameter of:
--
90 to 114 mm for 300 mm diameter antennas,
--
114 mm for 600 mm diameter integrated antennas.
CAUTION:
If the pipe diameter is smaller than the one mentioned above, the fixing brackets of
the pole mounting must be replaced by the kit 9400UXI103 that improves the wind
resistance of the whole equipment. This kit is especially recommended for the
600 mm antennas on 76 to 90 mm tubes.
There are also supports for fixing the pole to the wall: please consult us.
Various antenna types and sizes can be used, together with radio systems operating at different frequencies
and in a variety of configurations.
CAUTION:
Take care not to damage the O--Ring on the nose of the antenna connection.
If the ODU is not to be mounted immediately after the pole mounting of the antenna,
protect the connection nose (from water, dirt and impact).
For installation with non--integrated antenna, please refer to the antenna manufacturer recommendations.
Summary of Contents for 9400 UX
