75/314
3CC08991ATAA TQ BJA 01
Issue 01 -- March 2004
Vertical polarization
Horizontal polarization
TOP
TOP
Socket cap screw
“Antenna nose” slots
O-ring seal
ANTENNA - NOSE END VIEW
Drain orifice
Nose
Socket cap screw
Socket cap screw
TOP marker
vertical polarization
To change the polarization: undo the three socket cap screws and turn the nose through 90 degrees then
tighten the screws again.
CAUTION: The seal should be coated with silicone grease before fitting (the grease is
provided with the antenna).
3.5.3 -- Installing the configuration with pole mounting 1 + 0 (9400UXI102)
The antenna is screwed on the pole mounting 9400UXI102. The ODU is mounted with quick latches.
Overall antenna steer (with turnbuckles set to the “maximum”) is:
S
Azimuth: 360 degrees for a 300 mm and 600 mm diameter antenna, around the pipe.
The steer obtained by the turnbuckles is:
S
Elevation:
25 degrees,
S
Azimuth:
10 degrees.
To avoid obstacles (wall too close, etc), you can fix the pole mounting on any side of the pipe. The dimensions
of the outdoor equipment are given in § 3.2.1.
NOTE: The pole mounting 9400UXI102 is not designed to be fixed directly to the wall
Procedure :
--
1) Position the antenna vertically (nose horizontal), with the drain hole in the bottom part and free of
obstacles.
--
2) Insert the 7 M6 screws 1 with their “onduflex” springy crinkle washers 2 , tighten and secure the
screws (these screws can be found in a plastic bag located inside the casting.
Summary of Contents for 9400 UX
