87/314
3CC08991ATAA TQ BJA 01
Issue 01 -- March 2004
INSTALLING THE HSB COUPLER
IMPORTANT NOTE: NEVER REMOVE THE ROUND YELLOW PADS THAT ARE USED
TO SEAL THE OUTDOOR SYSTEM.
The coupler is supplied with vertical polarization (see § 3.5.2). The procedure for changing the polarization of
the HSB coupler is described in that section (see § 7.13). This must be done before installation.
To install the HSB coupler assembly:
--
take it by the handle, offer up the two bosses located in the “nose” of the coupler on the side of the
antenna port, to the grooves in the nose of the antenna,
--
Do not remove the sealing window located on the antenna port. The ODU/coupler/antenna
assembly requires no additional seal on the flanges; the flanges are smooth and sealing is provided
by the O--ring seal located around the male “noses”.
--
fix the coupler using three M6 x 35 mm screws and nuts in the holes in the top “lugs” of the pole
mounting.
--
secure the coupler by the two side screws (M6 x 30) on the pole mounting.
O-ring seal
Standby ODU
Antenna
port
Fixing holes on radio support ring of “pole
mounting”
Side fixing holes on
“pole mounting” arm
CAUTION: The seal should be
coated with silicon grease before
assembly
CAUTION: The seal should be coated with silicon grease before assembly (the grease
is provided with the HSB).
INSTALLING ODU
The positions of the main and standby ODUs are shown in the previous figures; for installing the ODUs, see
§ 3.5.4.1.
3.5.5 -- Installation with non-integrated antenna
3.5.5.1 -- Method
--
Install the antenna on the pipe, according to the instructions given by the manufacturer and supplied
with the antenna, and prepoint the antenna towards the remote station using a compass and a pair of
binoculars,
--
Install the pole mounting on the pipe, see § 3.5.4.3,
--
Install the HSB coupler on the pole mounting (only for 1+1 configuration), see § 3.5.4.5,
--
Install the ODU, see § 3.5.4.1,
--
Install the flextwist (suited to the frequency) between the pole mounting and the antenna, see § 3.5.5.6.
Summary of Contents for 9400 UX
