The T1/E1 Menu
Page 33-3
The T1/E1 Menu
The commands for configuring and monitoring
T1
and
E1
ports are contained in the
te
submenu. This submenu displays as shown below and may be accessed (when in verbose
mode) by entering
te
at a system prompt.
Command
T1/E1 Port Management Menu
--------------
--------------------------------------------------------
tes
View status of a T1/E1 port configuration and statistics
temod
Modify a T1/E1 port configuration
tecls
Clear framer statistics of a T1/E1 port
telts
Display 24-hour period statistics of a local T1/E1 port
telcs
Display current 15-minute statistics of a local T1/E1 port
telis
Display 15-minute interval statistics of a local T1/E1 port
terts
Display 24-hour period statistics of a remote T1/E1 port
tercs
Display current 15-minute statistics of a remote T1/E1 port
teris
Display 15-minute interval statistics of a remote T1/E1 port
tebcfg
Configure BERT test
tebs
Display BERT statistics
tebcls
Clear BERT statistics
tecfg
Configure T1/E1 port type
The commands in this menu are described in the following sections. The first command,
tes
,
displays configuration information on ports. This configuration information is configured
through the
temod
command. The remaining commands, listed after the
telts
command
provide a variety of interval statistics for local and remote
T1
and
E1
connections.
♦
Note
♦
The
tebcfg
,
tebs
,
tebcls
, and
tecfg
commands apply
only to the OmniAccess 408 and 512. For the Omni
Switch/Router, these are nonfunctioning commands.
Summary of Contents for Omni Switch/Router
