Page 35
34
7.
ADDITIONAL
INFORMATION
7.1
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The screen have no display.
There is no dial tone.
The telephone is not properly
connected.
Try re-connecting the telephone.
Pick up the handset and wait for
the information to be displayed
on the screen.
Or insert the batteries.
(See installation section)
Refer to the " Selecting and
adjusting the melody & the
Volume" chapter.
The telephone was not
initialised or the batteries
are not in place.
The ringer has been disabled.
The screen have no display.
There is dialing tone.
The telephone does not ring.
No dialing tone when the set is
connected to a "Telephony on
Internet" box.
The phone is configured
in pulse dialing mode.
1. Unplug the line code.
2. Remove the batteries
(if batteries are used).
3. Wait for a minute.
4. Replace with battery.
In case of use without batteries,
connect the line cord.
5. Within 2 seconds, press
" " key, then " R " key.
Unable to unlock PIN.
Wrong PIN code.
Press "Menu" key, then "OK".
Go to "CALL SETTING"
press "OK".
Go to "DIAL MODE" Press "OK".
Choose "TONE" Press "OK".
(All memory & setting will be deleted)