5
2.1. General information
Caution:
the purpose of this document is to guide the installation of the unit. For a fully-compliant installation, refer to the legislation in force in the
country of installation (e.g. NF DTU 68-3 part 1.1.4).
• Access
Connection box
Access electrical board recessed Torx screwdriver T30
Unit power supply: Single-phase 230 VAC + E
VEX410 coil power supply (as per options): Three-phase 400 VAC + N + E
VEX420 to VEX440 coil power supply (as per options):
Three-phase 400 VAC + N + E
Aeraulic
component
access with
Torx screws
M6
Aeraulic component
access with Torx T30
screws M6
The unit's rating plate is duplicated. One plate is located on the back of the quick access hatch and another on the side panel.
The unit is packed in plastic film, protected with cardboard corners. All accessories ordered with the unit are supplied unfitted. See Section 0 for the
fitting of accessories.
Caution:
do not drill into the panel between the two access doors or the floors as they carry cable networks!
2.2. Transport on site
The unit is mounted on cross bars. When using a forklift truck for transport, make sure that the forks are long enough to support all the side rails. Make
sure you do not damage the cross bars when inserting the forks under the unit (plan for a gap of at least 200 mm).
Side rails
Cross bars
Fork spreading min. 350 mm
2. INSTALLATION
