13
service@eurocentra.net
AFTER SALES SUPPORT
USA
1-866-558-8096
PRODUCT CODE: 91960 01/2015
USA
Start of cleaning
Place the ultrasonic cleaner on a level surface.
Place your objects in the cleaner and
fi
ll with water as instructed.
To reduce the noise level, you can close the cover, but it not necessary for the funtionallity.
Plug in the unit.
The red control lamp will illuminate on the operating panel.
Press the
ON
button to start cleaning; The blue container illumination lights up inside the
device and goes out after completion of the cleaning process.
Timer
The appliance has an electronic 5-Step-timer. With this timer you can choose the length of the
cleaning cycle.
Please press the
SET
button until the display shows the desired time. You can choose a cleaning
cycle of 90 - 180 - 300 - 480 or 600 seconds.
90 seconds:
Recommended for very light cleaning is needed or when a second brief cleaning
procedure is required. If the water is found to be dirty, the liquid has to be replaced. In order to
remove any residual dirt on the surface you should clean the item again for 90 seconds in the
fresh liquid.
600 seconds:
Recommended in order to intensify the cleaning e
ff
ect.
