ALDI FERREX 63349, User Manual

20V Pressure Spray Gun

AFTER SALES SUPPORT

e-mail:  info.aldi@positecgroup.com

1300 889 028

MODEL: №. CHW18W.91   •  01/2021  •  63349

(toll free)

14

Starting and Stopping

1.   Before first use: If using the 6m hose and alternate water source, remove 

any air trapped in the 6m hose (11) by placing the power nozzle (6) 

below waist level and attaching the extension lance (7). 

2.   Then start the spray gun by pressing the lock-off switch (1) and the on/

off switch lever (2). Depending on the water source, it may take up to 30 

seconds for water to travel along the 6m hose (11) and begin spraying. 

To stop the spray gun, release the on/off switch lever (2).

Watering (Fig H)
NOTE:

 It is recommended to use the shower mode for watering.

Cleaning (Fig I, J) 

WARNING: Do not connect the spray gun to water supplies that 

are dirty, rusty, muddy, or corrosive. (Including window 

cleaning liquids, plant foods, or fertilizers etc.)
NOTE: 

Not recommended for use with salt water; immediately rinse with 

fresh water for proper maintenance.

Residual risk

Even if you use the 20V Spray Gun properly per the instructions provided 

and following all safety notes, there are always residual risks. The following 

risk may occur:

-     Accidental Starting: Always remove the battery pack from the spray gun 

before carrying out any adjustment, servicing or maintenance.  When 

not in use, store the battery in a safe, dry, clean environment.

-    Risk of fluid injection: Do not direct the output of the spray gun at any 

person, the operator, or any animals.  Never place hands in front of 

H

I

J