Cleaning
15
3. Place the slide switch at OFF if you no longer need the paper shredder.
The LED ready indicator goes out.
4. Disconnect the power plug
1
and empty the waste bin.
There is a paper sensor
3
in the centre of the feed-in slot for
paper
2
. It detects the paper inserted and activates the cutters in
the paper shredder. For this reason, always push smaller paper for-
mats into the centre of the slot.
Using the REV setting
Use the REV setting to put the cutters into reverse operating direction.
1. Move the slide switch
5
to the REV position.
The cutters run in reverse and move the fed paper back out of the shredder.
2. Take the paper out of the shredder in order to continue with the shredding
process (see “paper jam” in the fault table).
Cleaning
NOTICE!
Risk of short circuit!
Water that has penetrated the housing may cause a short circuit.
− Disconnect the power plug before cleaning.
− Never submerge the paper shredder in water.
− Make sure that no water penetrates the housing.
NOTICE!
Risk of damage!
Improper handling of the paper shredder may result in damage to
the paper shredder.
− Do not use any aggressive cleaners, brushes with metal or
nylon bristles, sharp or metallic cleaning utensils such as
knives, metal sponges and the like. They could damage the
surfaces.
