AFTER SALES SUPPORT
1300 777 137
service@unclebills.com.au
MODEL: EA2259 PRODUCT CODE: 708978 07/2022
9
3. Thread one end of the strap (with the underside
or the buckle facing upwards) through one of the
brackets located on Binoculars (Fig. 4).
NOTE: The end of the strap may catch when threading
through the brackets. If this happens, bend the end of
the strap so that the end curls slightly upwards, then try
again. It may take a few attempts to thread the end of
the strap through the bracket.
4. Thread the strap back through the slider (Fig. 5).
5. Release the tension on the strap remaining in the buckle
(make sure the top strap is now loose and in a loop
so you can easily feed the bottom strap through the
underside of the buckle under the top strap). Thread the
end of strap through the underside of the buckle (Fig. 6).
6. Pull the strap until it is tight and secured into place (Fig. 7).
7. Repeat steps 2-6 to attach the strap to the bracket on
the other side of the Binoculars.
8. Place the Binoculars upright so that the eyepieces are pointing upwards, and the
brackets and strap are closest to you. Hold the strap together tightly, slide the buckle
and slider toward the bracket (Fig. 8 and Fig. 9). Repeat for the other side.
GETTING STARTED (CONT.)
Fig. 4
Fig. 6
Fig. 5
Fig. 7
Fig. 9
Fig. 8