Basic functions
22
1. In standby mode, hold the SET button
3
down for approx. 2 seconds until the 24 hr indi-
cator starts to blink on the display.
2. Then push the SET button 6 more times until
the LCD indicator briefly appears on the LCD
display and until the ON indicator flashes right
afterwards.
3. If you now push the MEM button
9
, the OFF
indicator will start to blink on the display.
4. Then push the SET button to save this setting.
The thermometer will now return to standby
mode and will now automatically switch off ap-
prox. 1 minute after the last button activity.
5. If you would like to set the thermometer back
to continuously standby mode, you can set the
LCD/OFF setting to ON according to the descrip-
tion above.
°Celsius/°Fahrenheit setting
1. Push the MEM button
9
to switch to memory
mode.
2. Then hold the SET button
3
down for approx.
2 seconds until the temperature measurement/
indicator switches from °C (degrees Celsius)
to °F (degrees Fahrenheit/1 signal tone) or
vice-versa from °F (degrees Fahrenheit) to °C
(degrees Celsius/2 signal tones).
Setting the date and time
In standby mode and in memory mode, the ther-
mometer displays the room temperature, time and
date in alternation. The two blinking dots between
the hours and minutes indicate the second intervals.
