Digital Inverter Generator with Pure Sine Wave
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. EP2800i • 09/2018 • 62007
(toll free)
AFTER SALES SUPPORT
(toll free)
Digital Inverter Generator with Pure Sine Wave
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. EP2800i • 09/2018 • 62007
20
21
Starting your Generator
NOTE: As the oil tank is not shipped with oil before starting the engine,
ensure you have filled the oil tank to the correct level with oil, and make sure
fuel has been added to the fuel tank (26).
1. Before starting, check to ensure the 240Va.c Outlet Power On/Off switch
(1 ) is in the right hand side “OFF” position, and ensure that no electrical
appliance is connected to the generator by removing any appliance cords
from the outlets (Fig. K/L).
2. Turn the fuel tap / lever (23) clockwise to the ‘ON’ position (Fig. M).
When vertical it is in the correct position.
3. Push the choke lever (16) towards the front of the generator to the full
choke “START” position (Fig. M). Choke is not necessary if the engine is
already warm and you’re restarting. The direction for the choke is also
indicated below the choke lever (16) on the air filter cover (17).
Operation
Operation
K.
L.
OFF
Engine oil replacement
1. Place the generator on a flat and level surface and
warm up the engine for several minutes. Then stop
the engine.
2. Place an oil pan at the front of the generator
ensuring it is in front of the oil filler cap/dipstick
(12) area. Commence removing the oil filler cap/
dipstick (12) by rotating in an anti clockwise
direction to remove, so that the oil can be
completely drained from the oil reservoir.
WARNING: Oil may be warm to hot. It is recommended to wear gloves
for protection.
3. Tilt the generator forwards (Fig I), so that the oil can drain from the oil
reservoir into the oil pan.
4. Reinstall the oil filler cap/dipstick (12) and rotate in a clockwise direction
until secure.
5. Refer to the previous instructions on page 18 for “Filling and checking the
engine oil” to refill the oil reservoir.
CAUTION. Check that no foreign material, debris, dust enters the crankcase.
6. Ensure to replace the oil filler cap/dipstick (12) after refilling with fresh oil by
securing it in a clockwise direction.
N.
RUN
FRONT OF GENERATOR
START
M.
ON
OFF
Operation
Before Starting your Generator Economy mode
This inverter generator is fitted with an economy
switch (29).
When the economy switch is turned on (Fig J),
the speed of the generator motor is reduced, thus
reducing fuel consumption, noise and ware and tear.
This economy setting is suitable for all low current
draw appliances.
In the event a larger appliance is turned on, the speed of the generator is
automatically increased to maintain a constant output.
Where a large appliance is known to be used, it is always better to turn the
Eco Switch to the OFF position so the sudden increase in power requirement
is not effected with the speed of the motor building up to speed.
J.
ON
I.
