12
Preparation
IRE
GB
Setting up the compressor
Observe the following notes when setting up the compressor:
NOTE!
Risk of damage!
If you set up the compressor in an unsuitable location, you
could damage it.
− Place the compressor on an easily accessible, level, dry
and sufficiently stable work surface. Do not place the
compressor along the edge of a surface, e.g. on a kerb.
− Avoid any build-up of heat by not setting the com-
pressor up directly against a wall or similar. Make sure
that the vents are not obstructed. During operation,
always place the compressor on the rubber feet so
that it rests on its side.
− Do not place the compressor on or near hot surfaces.
− Set the compressor up in a location with dry and
clean air. Don’t use it in wet rooms or in the rain.
Connecting the compressor
WARNING!
Risk of electric shock!
A faulty electrical installation or excessive mains voltage
may result in an electric shock.
− Only connect the compressor if the mains voltage of
the socket corresponds to the nameplate specification.
− Lay the mains cord so that it does not pose a tripping
hazard.
− Only connect the compressor to an easily accessible
socket so that you can quickly disconnect it from the
power supply in the event of a fault.
− The compressor complies with protection class 2. Only
connect it to a properly installed socket. Connection
to a multiple socket strip or multi-socket is impermis-
sible and increases the risk of fire.
Summary of Contents for WorkZone WZK 183
Page 4: ...A B 1 2 3 4 6 5 7 10 11 12 9 8 4 Overview GB IRE...
Page 5: ...C D G E F 1 2 5 Use IRE GB...
Page 24: ...24 IRE GB...
