16
Use
IRE
GB
NOTE!
Risk of damage!
Using the compressor improperly may damage it.
− Observe the designated type of operation: S3 15 %
10 min. This means that the compressor is intended
for intermittent operation without the influence of the
starting process and that the operating time may not
exceed 1.5 minutes (15 %) within a period of 10 min.
− Use all hoses and fittings adequately in accordance
with the work pressure.
− Do not tilt the compressor while in operation. Only
leave it on the base in a horizontal position and do
not carry it while in operation.
You can use the compressor to supply various articles with compressor air, use the
compressor as a blow gun and use the vent valve during operation.
Supplying articles with compressed air
You can supply various articles such as bike and car tyres, balls and air mattresses
with compressed air. Proceed as follows:
1. Prepare the compressor (see chapter “Preparation”).
2. Make sure that the adapter
10
/
11
/
12
is properly inserted in the article's valve
and during operation, hold it so as to ensure that it cannot slip out of the valve.
3. Use the On/Off switch
3
to switch on the compressor.
4. Press the trigger of the tyre fill gauge
8
to supply the article with compressed air.
5. During operation, use the trigger to dose the compressed air.
6. Observe the pressure gauge during operation. Observe the maximum permissible
pressure for the respective article.
7. Once the desired pressure has been reached, release the trigger.
8. Use the On/Off switch to turn off the compressor.
9. Pull the adapter out of the valve.
10. Pull the mains plug out of the socket.
11. Push the trigger again to depressurise the compressor.
12. Clean the compressor (see chapter “Cleaning”).
Summary of Contents for WorkZone WZK 183
Page 4: ...A B 1 2 3 4 6 5 7 10 11 12 9 8 4 Overview GB IRE...
Page 5: ...C D G E F 1 2 5 Use IRE GB...
Page 24: ...24 IRE GB...
