17
Cleaning
GB
IRE
Using the blow-out adapter
You can use the compressor as a blow gun to clean dust and similar dirt out of cavities
or difficult to reach areas. Proceed as follows:
1. Prepare the compressor (see chapter “Preparation”).
2. Point the blow gun at the desired area.
3. Push the trigger of the tyre fill gauge
8
.
4. During operation, use the trigger to dose the compressed air.
5. Once you have cleaned the desired areas and surfaces, use the On/Off switch
3
to turn off the compressor.
6. Pull the mains plug out of the socket.
7. Push the trigger again to depressurise the compressor.
8. Clean the compressor (see chapter “Cleaning”).
Using the vent valve
You can use the vent valve on the side of the tyre fill gauge to lower an increased
pressure.
1. During operation, use the pressure gauge to continually check the pressure.
2. If e.g. you determine that there is too much pressure in a bike tyre, briefly push the
vent valve to release any surplus air.
Cleaning
Clean the compressor and accessories after every use.
NOTE!
Risk of short circuit!
Water that has penetrated the housing may cause a short
circuit.
− Do not immerse the compressor or the accessories in
water.
− Make sure that no water penetrates the housing.
Summary of Contents for WorkZone WZK 183
Page 4: ...A B 1 2 3 4 6 5 7 10 11 12 9 8 4 Overview GB IRE...
Page 5: ...C D G E F 1 2 5 Use IRE GB...
Page 24: ...24 IRE GB...
