If the supply cord is damaged, it must be replaced by a special cord or assembly
available from the manufacturer or its service agent.
Please provide the following information in the event of any enquiries:
•
Type of current for the motor
•
Machine data - type plate
10. Troubleshooting
Fault
Possible cause
Remedy
The compressor
does not start.
• No supply voltage.
•
Insufficient supply
voltage.
• Outside temperature is
too low.
• Motor is overheated.
• Check the supply voltage, the
power plug and the socket-outlet.
• Make sure that the extension cable
is not too long. Use an extension
cable with large enough wires.
• Never operate with an outside
temperature of below +5° C.
• Allow the motor to cool down. If
necessary, remedy the cause of the
overheating.
The compressor
starts but there
is no pressure.
• The seals are dam-
aged.
• Check the seals and have any
damaged seals replaced by a
service center.
The compres-
sor starts but
the tools do not
start.
• The hose connections
have a leak.
• A quick-lock coupling
has a leak.
• Check the compressed air hose
and tools and replace if necessary.
• Check the quick-lock coupling and
replace if necessary.
11. Maintenance & Cleaning
m
Important!
Pull out the power plug before doing any cleaning and maintenance work on the
equipment. Risk of injury from electric shock!
m
Important!
Wait until the equipment has cooled down completely! Risk of burns!
AUS
Electrical connection / Troubleshooting/Maintenance&Cleaning
AIR FORCE
18
AFTER SALES SUPPORT
support@scheppach.com.au
1300 855 831
MODEL: AIR FORCE PRODUCT CODE: 56102 02/2018
