16
35
6
5
G7
G7
16
6
6
16
F5
F5
F3
F3
F3
(x4)
(x4)
M6 BOLT 60mm (X4)
F6
5
35
5
35
F6
F6
M8 BOLT 59mm (X1)
M6 BOLT 52mm (X12)
M8 BOLT 65mm (X4)
F5
83
Nest Swing & Glider - BSW08
Step 1.
Insert tapered end of Top Bar 1 into the end of Top Bar 2. Make sure there
is only 1 set of holes in the end connected to Top Bar 1.
Step 2.
Use 1 F2 fastener to connect Top Bar 1 to Top Bar 2
**Always Make sure to place included washers between fastener head or nut
and adjoining swing components**
Step
3
.
Insert 1 Top Leg segment into either side of the T-shaped Connector,
secure with 2 F3 fasteners per Leg. Repeat for both Connector and Top Legs
assemblies.
Step 4.
Insert either end of assembled Top Bar into Connecter and Leg Assemblies.
Use 2 F5 fasteners on each side to attach
.
Step 1.
Completely disassemble F1 U-Bolts then place u-shaped bolt through the
hole in the bearing assembly found at the end of the Swing ropes.
Step 2.
Tighten open-ended F1 nut down onto u-shaped bolt, place 1 F1 washer on
each end of the bolt and insert into Top Bar through 2 sets of vertical holes. Ensure
washer placement between nuts and Top Bar.
Step 3.
Place 1 F1 washer on the exposed threaded ends of the F1 bolt, then attach
F1 cap nuts and tighten down. Repeat for both sets of Swing ropes.
Attach Swing to Assembled Frame
Nest Swing Assembly
Fig. 1
Attach Bottom Legs and Side Stay Bar
Step 1.
Insert 1 Bottom Leg into the open end of each of the 4 Top Legs. Place
a F3 fastener into each of the holes at the junction, making sure the exposed
threaded end is pointed away from the Nest Swing
(Fig. 1)
.
Step 2
.
Place Side Stay Bar over the exposed fastener ends so that the flat side
of the Stay Bar ends is in contact with the Top/Lower Leg assembly
(Fig 1)
.
Step 3.
Tighten F3 nut down onto Side Stay Bar.
