M6 BOLT 32mm (x4)
43
Glider Assembly
Step 1.
Slide Glider bracket over Top Bar on Glider side and align to the 2
horizontal holes
(Fig. 2)
.
Step 2.
Attach Glider Bracket to Top Bar using 2 G1 fasteners.
Step 3.
I
nsert 1 G8 Plastic Spacer into the holes on either side of the Glider Handle
Tubes.
Step 4.
Attach curved upper bar portion of Glider Handle Tubes to holes on bottom
corner of the Glider Bracket using 1 G2 fastener for each side
(Fig. 3)
.
Step 5.
Insert tapered segment of Glider Legs into exposed open side of Glider
Handle Tubes, use 2 G6 fasteners on either side to attach.
G7
83
G7
Step 6.
Insert 1 G9 Plastic Spacer into either side of the holes near the center of the
Glider Legs
(Fig. 4)
.
Step 7.
Attach the Glider Seat Tubes to either side of the Glider Legs by placing a G4
fastener through the same holes that the G9 Spacers have been installed in.
Step 8.
Fa
sten Glider Seat to Glider Seat Tubes using 4 G7 Fasteners in both sets of
holes on both Seat Tubes. Repeat to assemble both Seats.
Step 9.
Use G5 fasteners to secure Glider Footrest to lower holes in Glider Legs
Fig. 2
Fig. 3
Fig. 4
