Low-Pressure Transfer Pump
SER 9616-A
Alemite Corporation
7
Revision (10-98)
25
29
27
21
5
6
7
8
9
11
10
12
13
14
17
15
19
20
22
5
23
33
30
32
31
34
16
10
18
24
26
Weep
Hole
13. Install O-Ring (
25
) onto the Stop.
14. Install and seat Spring Discs (
32
) in an alternate
pattern into Valve Body (
34
).
• See
Figure 4
for details.
IMPORTANT: Make sure to press O-Ring
(
30
) fully into the groove of Seat (31).
15. Install and seat O-Ring (30) into Seat (31).
16. Install the Seat assembly [O-Ring upward] into
the Valve Body.
17. Install Ball (29) into the Seat.
18. Install and seat O-Ring (33) onto the groove of
the valve Body.
19. Screw the Valve Body assembly onto the Stop.
• Tighten the Valve Body securely.
20. Install Air Motor Assembly (4)squarely onto the
Body.
• Use care passing the O-Ring.
• Make sure the outlet of the Body orients
properly with the inlet of the Air Motor.
21. Install the Cylinder assembly squarely onto the
bottom of the Outlet Body.
• Use care passing the O-Ring.
22. Install and seat Ring (27) [counter bore end
first] onto the Cylinder.
• Rotate the Ring until the holes align with the
Air Motor Assembly.
23. Install Screws (28) that secure the Ring to the
Air Motor Assembly.
• Tighten the Screws evenly and securely in a
crisscross pattern.
24. Screw Bushing (12) [with thread sealant] into
the Outlet Body.
• Tighten the Bushing securely.
Air Motor Assembly
25. Screw Shut-Off Valve (3) [with thread sealant]
into the Air Motor Assembly.
• Tighten the Shut-Off Valve securely in the
position required.
26. Screw Adapter (2) onto the Shut-Off Valve [with
thread sealant].
• Tighten the Adapter securely.
27. Install Air Coupler (1) onto the Adapter.
Figure 4
Pump Tube Assembly - Section View
Refer to Figure 2 Parts List
for Parts Identification
1-800-548-1191-http://www.partdeal.com-info@partdeal.com