Visit our website at
www.alemlube.com.au
or
www.alemlube.co.nz
NSW/ACT
TEL: (02) 9677 1555
FAX: (02) 9675 1155
QLD/PNG
TEL: (07) 3204 9166
FAX: (07) 3204 1224
VIC/TAS
TEL: (03) 8787 8288
FAX: (03) 8787 8266
WA
TEL: (08) 9302 4199
FAX: (08) 9303 2095
SA/NT
TEL: (08) 8241 7111
FAX: (08) 8241 7011
NZ
TEL: (64) 9 447 1007
FAX: (64) 9 447 1008
10 of 16
OPERATION
6) Hold the housing of the pump securely and pull the starter grip then pull briskly.
CAUTION
Do not allow the starter grip to engine snap back against the engine. Return it gently to prevent damaging the starter.
NOTE
Always pull the starter grip briskly. If not pulled briskly, it will result in failing to start the engine.
CAUTION
Never use the pump for muddy water, waste oil, wine etc. Do not pull the governor linkage to operate the engine forcibly
outside its design parameters.
Turn the governor lever to the desired engine speed position.
Discharge flow is controlled by adjusting the engine speed.
Moving the governor lever to the FAST position will increase the flow, and the SLOW position will decrease pump flow.
9
6) Hold the housing of the pump securely and pull the starter grip
thenpull briskly.
Do not allow the starter grip to engine snap
Returnit gently to prevent damaging the starter.
Always pull thestarter grip briskly. If not pulled briskly, it will result in
failing to start the engine
6. OPERATION
Never use the pump for muddy
the governor linkage to operate
parameters.
Turn the governor lever to the desired engine speed position.
Discharge flow is controlled by adjusting the engine speed. M
theFAST position will increase the flow, and the SLOW position will decrease pump
flow..
6) Hold the housing of the pump securely and pull the starter grip until you feel resistance,
Do not allow the starter grip to engine snap back against the engine.
prevent damaging the starter.
briskly. If not pulled briskly, it will result in
Never use the pump for muddy water, rejected oil, wine, etc.Do not pull
ge to operate the engine forcibly outside itsdesign
Turn the governor lever to the desired engine speed position.
Discharge flow is controlled by adjusting the engine speed. Moving the governor lever to
low, and the SLOW position will decrease pump
9
6) Hold the housing of the pump securely and pull the starter grip
thenpull briskly.
Do not allow the starter grip to engine snap
Returnit gently to prevent damaging the starter.
Always pull thestarter grip briskly. If not pulled briskly, it will result in
failing to start the engine
6. OPERATION
Never use the pump for muddy
the governor linkage to operate
parameters.
Turn the governor lever to the desired engine speed position.
Discharge flow is controlled by adjusting the engine speed. M
theFAST position will increase the flow, and the SLOW position will decrease pump
flow..
6) Hold the housing of the pump securely and pull the starter grip until you feel resistance,
Do not allow the starter grip to engine snap back against the engine.
prevent damaging the starter.
briskly. If not pulled briskly, it will result in
Never use the pump for muddy water, rejected oil, wine, etc.Do not pull
ge to operate the engine forcibly outside itsdesign
Turn the governor lever to the desired engine speed position.
Discharge flow is controlled by adjusting the engine speed. Moving the governor lever to
low, and the SLOW position will decrease pump
5
6 OPERATION
