www.aleratec.com
10
Using the USB Duplicator
2. Press the
OK
button on the display panel. The USB Duplicator will start
to read the source content into the system’s buffer and immediately start
copying any loaded target USB flash drives.
3. Load the blank target flash drives into the USB Duplicator. The LCD will
display the number of blank media loaded and copying.
Note:
When copying is in process the Green LED on the front panel is
blinking. Do not take out the drive while it is copying. When copying is
finished the Green LED stays on (no blinking). If an error occurs during the
copy process a Red LED will display.
4. As finished drives are removed, and new blanks inserted, the display
will show the number of copies completed and the number of USB
flash drives still in the copying process. If the Copy fails, the LCD will
display the number of flash drives that failed and passed.
Note:
During Asynchronous Copying you can use the
UP
and
DOWN
arrow keys to check each flash drives copying status.
USB(58M) 450M
Reading...
ESC
OK
Pass: 0
Working
Fail: 0
3
ESC
OK
Pass: 5
Working
Fail: 0
2
ESC
OK
ENT
ESC
ENT
ESC
ENT
ESC