Alert 450R, Owner'S Manual

.                                                           .

9

SAFE START (Child safety mode) 

(See Start Feature

 1 – 5 

Programming.)

Factory default settings to press the   

button

twice

 on the transmitter to

remote start the vehicle. Programming this feature to eliminate an accidental

remote starts.
This requires the user to press the transmitters   and   

buttons

 at the

same time to remote start the vehicle.

REMOTE START OPERATION

B. ENGINE START PROGRAMMING FOR VEHICLES WITH MANUAL

  TRANSMISSIONS 

(Cut the 

VIOLET LOOP

wire

 for a manual transmission

vehicles)

The control module senses the neutral safety switch position on a automatic

transmission vehicle and no prior set-up required. The system for the manual

transmission vehicles follows this process when you exit the vehicle to sense

and memorize the neutral safety switch position. If the vehicle has a automatic

transmission, this process is omitted.

1. While the engine is running with the ignition key, set the emergency

brake and place the manual transmission in the neutral position.

2. Before turning off the engine, press the   

button

twice

 on the transmitter.

-- The LED indicator will flash 3 times to confirm it has been entered.

3. Turn off the “Ignition Key” and remove it from the ignition switch.

--The engine should continue running until the pre-programmed time has

elapsed or the shutdown input is received.--

4. Exit the vehicle and close all doors.

-- The engine should still continue running and this is a normal operating

procedure.--

5. Within

1 minute from the time of step 1, press the   

button

 on the

transmitter to lock the doors.

6-1. If the engine shuts down immediately, the system is now ready for

remote engine starts.

6-2. If the engine does not shut down immediately, the system has failed.

Repeat the above process again.

If a door is opened after the above procedure, the prior memorization for

the next remote or programmed engine start sequence is deleted and the

remote start function will not work until you repeat the above process again.

Note:

 If the remote start programming is set up, the dome light supervision

function will be

temporarily

By-passed.