Alfa Laval Toftejorg SaniMidget SB Series, Instruction Manual

Installation and Normal Operation 

Instruction Manual, Alfa Laval Toftejorg SaniMidget SB 

Page 9 

IM-TE91A720_EN2 
 

Installation and Normal Operation 

General Installation Instructions 

It is recommended to install a filter with mesh size 250 µm (0.01”) in the supply line in order to avoid 
particles, scale etc. from clogging the inside of the cleaner.  
 
Before installation, all supply lines and valves must be thoroughly flushed

to remove remains from 

welding, grinding dust, scale and other foreign matter. During handling and installation handle the 
machine with care in order not to damage the fine surface of the machine. 
 
Randomly selected SaniMidget SB machines are tested at the factory before shipping, in accordance 
with “Test Requirements for SaniMidget SB/3-A”

.

Note:

 The machine shall be installed in accordance with national regulations for safety and other 

relevant regulations and standards. In EU-countries the complete system must fulfil the EU-Machinery 
Directive and depending of application, the EU-Pressure Equipment Directive, the EU-ATEX Directive 
and other relevant Directives.  

Pos. 1 

Connector 

Pos. 2 

Rotor 

Pos. 3 

Stator 

Pos. 4 

Clip 

Important 

information: 

Recommended installation position:  

The Rotary Spray Head tank cleaning machine should be installed in vertical position 
(upright or upside down). If the machine is installed in any angle to vertical, the life 
time may vary. If installing at an angle to vertical, ensure that the clip cannot fall out 
by gravity. To maintain drainability, the device should not be tilted more than 25° to 
vertical.