16
DANGER
In the event of fire in the smoke exhaust pipe,
keep all people and pets away from the room, immediately switch
off the power supply by using the main switch in the house or by pulling the plug from the wall (the plug must
always be easily reachable and free), and immediately call firemen.
DANGER
Typical wood for stoking cannot be used.
DANGER
Do not use the stove for burning waste.
8.0 THE QUALITY OF PELLETS IS VERY IMPORTANT
This stove has been designed to use pressed wood (pellets) as fuel.
Since there are many products of this type on the market, it is important that you choose pellets as fuel which is not
dirty. Make sure to use quality pellets which are compatible with a little dust as well.
Ask your vendor or the stove manufacturer about the best pellets, whose diameter should be about 6 to 7mm and a
length of about 30mm.
Proper operation of the stove depends on the type and quality of the pellet fuel, since
the heat obtained from different types of products can have different intensity.
The manufacturer of the stove does not assume any responsibility about the use of the pellet fuel with inappropriate
quality, neither about the bad operation of the stove which is a result to that fuel.
8.1.STORAGE OF PELLET FUEL
The pellets must be stored in a dry and not too cold room. Cold and wet pellets (with a temperature of about 5*C)
reduce the thermal strength and required more frequent cleaning of the stove.
THE PELLETS MUST NOT BE STORED DIRECTLY CLOSE TO THE STOVE.
Store them at least 2 meters from
the stove. Carefully manipulate with pellets, do not break them.
WARNING:
In case of placement of sawdust or small – crumbling pellets in the funnel part of the stove i.e. the fuel tank, this
may to block the dosage system of pellets (fuel). Such pellet may lead to disturbances in the operation of the
electro-motor that which drives the mechanism for inserting pellets, or may cause damaging of the redactor which
operates in connection with that electro motor. If at the bottom of the pellet tank, that is, on the bottom of the snail
transmission, when the tank is empty, you notice such small, crumbling pellet, clean it with a vacuum cleaner by
placing the vacuum cleaner hose through the openings of the pellet grate.
9.0 DESCRIPTION AND FUNCTIONING OF THE ELECTRONIC CARD
9.1 DESCRIPTION OF THE ELECTRONIC CARD (KEYBOARD)
(figure 17)
Button 1:
it increases the room temperature, shows the temperature of the chamber
Button 2:
reduces the room temperature
Both these buttons have program functions.
Button 3:
modification of the temperature and program functions
Button 4:
switched on/ switched of (ON / OFF) and exit from programs
Button 5:
reduces the heat capacity from 5 to 1
Button 6:
increases the heat capacity from 1 to 5
WARNING
Automatic programing of the ventilation with values from 1 to 5 has been factory adjusted and can be changed only
by authorized professional repairmen, and factory experts. They are informed from each separate case.