17
Figure 17
Electronic keyboard of controls
LED
→
L
ight
E
mitting
D
iode
→
Lamp
9.2 FUNCTIONING OF THE ELECTRONIC CARD
When it is already connected to the power supply, you should turn the switch which is located at the back side of
the stove into position 1. Then the following indication as shown in figure 18 appears:
Figure 18.
In order to start the stove,
press button 4. Shortly after this, the command to the electronics will put the stove into
a state of calibration, that is, preparation for work and the message shown in figure 19 appears on the display. The
suction device will be switched off for about 15 seconds, that it will be switch on again for maximum 7 seconds.
Figure 19.
Upon termination of this stage, which lasts about 20 seconds, the message
"LOAD WOOD"
appears as shown in
figure 20. The snail loader loads the pellets and the ignition heating element is on. This is shown on the display of
the control keyboard through the previously described LED lamps.
Figure 20.
When the temperature is sufficiently high )after about 15 minutes), reach in accordance with a certain coefficient
(about 3ºC per minute), the electronic command prepares the fuel ignition and the next stage of operation follows,
flame stabilization and then the display of the command board shows the message
"FIRE ON" (activated flame)
as in figure 21. The tangential fan (alternator) switches on at that moment as well.
State/power/title of parameter
LED chrono-active
Increase of temperature
Reduction of temperature
Set / menu
State of display/time/temperature values of parameter
LED modification for set temperatures
LED ambiental thermostat
Power reduction
Power increase
LED snail ON
LED data reception by remote control
ON/OFF
