The ignition is cycled to the ON and the
windshield wiper control is used.
If, after using the function, the ignition is
set back to ON with the blades in a
position other than rest position (at the
base of the windshield), they will only
return to rest position following a
command given using the stalk (stalk
upwards, into unstable position) or when
a speed of 3 mph (5 km/h) is exceeded.
Replacing The Windshield Wiper Blades
Proceed as follows:
1. Raise the wiper arm, push tab of the
attachment spring and remove the blade
from the arm.
2. Fit the new blade, inserting the tab in
the dedicated housing in the arm and
checking that it is locked.
3. Lower the wiper arm onto the
windshield.
Note:
Do not operate the windshield wiper with
the blades lifted from the windshield.
Front/Rear Windshield Washers
The window washer nozzles are fixed,
and are located on the front windshield
wiper arms, the rear windshield wiper
arm, and the rear spoiler. If there is no jet
of fluid, first check that there is fluid in
the reservoir (see paragraph “Engine
Compartment” in this chapter).
Then check that the nozzle holes are not
clogged; use a needle to unblock them if
necessary.
RAISING THE VEHICLE
If the vehicle requires lifting, visit an
authorized dealer which is equipped with
shop jacks or jack arms.
The vehicle lifting points are marked on
the side skirts with the
symbols.
Wiper Release Tab
Vehicle Lift Point Locations
198
SER
VICING
AND
MAINTENANCE
Summary of Contents for Stelvio 2019
