Alfatron ALF-SUK4T
18
7.2 HDCP Mode
Put switch 4 into “
ON
” position to select HDCP Active mode, or to “
OFF
” for HDCP
Passive mode.
Switch Status
Mode
HDCP
OFF (0)
Passive
(Default)
Automatically follows the HDCP version of source
device.
ON (1)
Active
If the input video has HDCP content, the HDCP
version of HDMI output is HDCP 1.4 for broader
video solution.
If the input video has no HDCP content, the HDMI
output has no HDCP either.
8. Firmware Upgrade
Please follow the below steps to upgrade the firmware via the Micro-USB port:
1) Prepare the latest upgrade file (.bin) by renaming it to: “FW_MERG.bin”
2) Power off the splitter and connect the Micro-USB (FIRMWARE) port of splitter to the
PC with a USB cable.
3) Power on the splitter, the PC will automatically detect a U-disk named of
“BOOTDISK”.
4) Double-click to open the U-disk, a file named “READY.TXT” will be shown.
5) Directly copy the latest upgrade file (.bin) to the “BOOTDISK” U-disk.
6) Close and Reopen the U-disk to check whether there is a new file named
“SUCCESS.TXT”, if yes, the firmware was updated successfully, if not, the
firmware update failed. The name of upgrade file (.bin) should be confirmed again,
repeat the above steps again to update.
7) Remove the USB cable and reboot the splitter after the firmware upgrade is
successful.
