User
PIN code
When joining a network your controller may or may not be aware of any previously saved user codes stored in the lock. It is
recommended that all user codes be deleted from the lock prior to joining a network.
Reset to factory default settings
Operations on lock
1. Open the door and keep the lock in “unlock” status
2. Open battery box and find the reset button.
3. Use a sharp thing to press and hold the reset button.
4. Keep holding the reset button and remove a battery from battery box then replace it.
5. Keep holding the reset button until hearing voice guide.
Function extension instruction(Z-wave,remote control, etc)
1. Follow the user guide of your hub to enter learning mode.
2. Operate on lock following guide below
2.1. Touch the screen with your hand to activate.
2.2. Enter “*” twice and the Master PIN Code followed by “#”.
2.3. Enter “81+ #” to pair.
Enter “82+ #” to unpair.
Micro USB emergency power supply and Reboot button
Micro USB
power port
Reboot button
Door lock can be connected to micro USB power bank when battery wears out.
Door lock can be restarted by press Reboot button when crash down.
How to use
Unlock the door
1. Unlock the door from outside
- Use PIN code key
2. Unlock the door from inside
- Manual thumb turn
Turn the thumb turn on inside body
In Auto re-lock mode, the bolt will be throwed out automatically in 30 seconds after unlock.
In Manual Mode, the device could be locked by turning the thumb turn on inside body..
In Auto re-lock mode, the device is locked automatically.
2. Lock the door from inside
Lock the door
1. Lock the door from outside
Auto Re-lock Mode
Manual Mode
Press and hold any key on keypad for 2 seconds.
Auto Re-lock Mode
Manual Mode
How to use
Unlock with Fake PIN code
User can prevent PIN code exposure from strangers by entering random digits before or after PIN code.
Power bank(Micro USB)
9/9
8/9
