Installation
Algas-SDI Operation and Maintenance Manual - VH100-VH200
2-5
Rotate the Rear Cover (Optional)
To rotate the rear cover, do the following (see Figure 2.1).
Disconnect the fuel piping at a union in the piping or the inlet
block provided on the burner (1).
Remove the four bolts on fuel inlet (1).
Remove the inlet block, O-rings, and Orifice Plate from the
rear cover (1).
NOTE:
Be careful not to lose or damage the orifice plate or the
O-rings.
Remove the four bolts on rear cover (2).
Rotate the rear cover (3) to the desired position.
Install the four bolts on rear cover (2).
Reconnect the inlet block, O-rings, orifice plate and the
piping. Verify that the O-rings show no signs of damage.
Figure 2.1 –
Rotate the Rear Cover
1
2
3
