Wireless Timing Network WTN-DB
-10-
4
Updating of the WTN-DB
To update a WTN-DB you need a WTN device. First you update the WTN as described
in the WTN manual and then you can transmit the new firmware to the WTN-DB. The
WTN-DB LED blinks red during the update.
Transmit New Firmware to Other WTN Devices <RF-UPD>
When you have several WTN-devices in a network you can make the update of the
firmware on one device through RS232 from a PC. This device can now update the
firmware of all other devices in the same network.
•
Update the WTN as described in the WTN manual
•
Switch on all WTN-devices that you want to update from the WTN with the new
firmware and check that they all use the same team.
•
Start the update as described below in the device with the updated firmware. For
the devices that you want to update you do not have to make any further ad-
justment.
•
Go to the submenu <SETTINGS> by pressing continuously the key „MENU“ (1)
for about 5 seconds.
•
Press „MENU“ (1) to move through the menu until it shows <RF-UPD>.
•
Press key „ON/OFF“ (2) to start the update.
•
Do not turn the WTN-WS off for two minutes after the update finished. Internal it
will reprogram itself and if you turn it off it will destroy the software and the WTN-
WS is defect.
