Step 4: Place eye bolt (E) into the hole at the top of the
upright support (as shown in Figure 5) Secure using a
washer (C) and a lock nut (D) tightening with the 2 piece
wrenches supplied.
Step 5: Clip a carabiner clip (F) onto each end of the
chains (G). Attach the hanging chain to the eye bolt on
each end of the stand (as shown in Figure 6.)
TO CONNECT YOUR HAMMOCK: Simply clip the O-ring at
the end of your hammock to the carabiner clip at the end
of the chain lengths (as shown in Figure 7). Adjust the
height of the hammock by moving the clip to an
alternative link in the chain length.
Step 6: Go back and tighten all nuts and bolts.
Caution: Care should always be taken when using your hammock stand but especially when using
the stand the very first time. Please always use extreme caution when getting into and out of your
hammock. Never exceed the weight capacity of the hammock or the hammock stand. Never allow
young children to use the hammock or stand unaccompanied by an adult. Always inspect your
hammock stand before each use to assure all parts are appropriately attached and tightened. Make
sure to read and follow your hammock care instructions.
Care and Storage: The Wooden Arc Stand is finished with a protective outdoor finish. To prolong the
life of the wooden stand try to store in a dry location especially through the winter months.
Please Note: When using your stand for the first time you’ll notice creaking noises as the pieces
settle in place. Once the stand has been used a few times the creaking noise will subside.
Figure 5
Figure 6
Figure 7
