10
1. Use a Phillips #2 screw driver to remove the back cover of the camera. See the photo above.
2. Insert the micro-SD card into the card slot until it clicks into place.
3. Pull the rubber retainer out and over the edge of the micro-SD card and PC board it attaches to.
4. Reattach the back cover.
2.3 Camera wall mount installation
Following the instructions below to install the camera using the
ALI-PTZWB Wall Mount Bracket
.
Instructions for mounting the camera with a
ALI-PTZPM Pole Mount PTZ Bracket
or
ALI-PTZCM Corner Mount PTZ
Bracket
are very similar. For these brackets, use the instructions below as a guide. .
1. Determine the best mounting screws and hardware to anchor the mounting bracket with the camera to the mounting surface.
Use the following guidelines:
—
For cement wall mounting, use the expansion screw to anchor the bracket.
—
For wooden wall mounting, use self-tapping screw to anchor the bracket.
—
Make sure that the wall is strong enough to withstand more than
8 times
the weight of the camera and the bracket.
2. Using the mounting bracket as a template, mark the location of the mounting screw holes on the mounting surface. Also mark
the location of a hole for the camera drop cable. The drop cable will be routed through the mounting bracket and through the
mounting surface.
3. Drill holes in the mounting screws and hardware. Also, drill a 1½” diameter hole in the mounting surface for the drop cable.
4. Apply two wrap of the thread tape provided onto the treads of the pendant adapter (see below)
Wrap with
thread tape
Bracket
Pendant adapter
Pendant adapter
set screw
Lock screw (2)
Loop for
safety cable
Attach pendant adapter to mounting bracket
SECTION 2: INSTALLATION
Summary of Contents for ALI-NS7012R
Page 6: ...vi NOTES ...