UPMIDIAS
20
| Replacing
the
Memory
Module(s)
Replacing the Memory Module(s)
WARNING:
Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 11. For additional safety best practices
information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
NOTE:
Your computer supports up to four memory module connectors. You can
access connectors DIMM3 and DIMM4 by removing the base cover at the bottom of
your computer. You can access connectors DIMM1 and DIMM2 by removing the
palmrest.
Procedure
NOTE:
If you need to install memory modules in two connectors, install a memory
module in the lower connector before you install a memory module in the upper
connector.
1
Align the notch on the memory module with the tab on the memory-module
connector.
2
Slide the memory module firmly into the connector at a 45-degree angle and press
the memory module down until it clicks into place. If you do not hear the click,
remove the memory module and reinstall it.
1
tab
2
notch
3
memory-module connector
3
1
2
Book.book Page 20 Friday, June 28, 2013 11:10 AM
