40
| Replacing
the
Processor
Module
Replacing the Processor
Module
WARNING:
Before working inside your computer, read the safety
information that shipped with your computer. For additional safety
best practices information, see the Regulatory Compliance
Homepage at www.dell.com/regulatory_compliance.
Procedure
NOTE:
If a new processor module is installed, you will receive a new
thermal-cooling assembly, which will include an affixed thermal pad, or you will
receive a new thermal pad along with documentation to illustrate proper
installation.
1
Align the pin-1 corner of the processor module with the pin-1 corner of the ZIF socket,
then place the processor module.
NOTE:
The pin-1 corner of the processor module has a triangle that aligns with the
triangle on the pin-1 corner of the ZIF socket.
When the processor module is properly seated, all four corners are aligned at the
same height. If one or more corners of the module are higher than the others, the
module is not seated properly.
CAUTION:
To prevent intermittent contact between the ZIF-socket
cam screw and the processor module when replacing the processor,
press to apply slight pressure to the center of the processor module
while turning the cam screw.
CAUTION:
To avoid damage to the processor module, hold the
screwdriver perpendicular to the processor module when turning the
cam screw.
2
Tighten the ZIF socket by turning the cam screw clockwise to secure the processor
module to the ZIF socket.
Postrequsites
1
Replace the processor heat-sink. See "Replacing the Processor Heat-Sink" on page 37.
2
Replace the processor heat-sink fan. See "Replacing the Processor Heat-Sink Fan" on
page 31.
3
Replace the compartment door. See "Replacing the Compartment Door" on page 15.
4
Replace the battery pack. See "Replacing the Battery Pack" on page 13.
22
Summary of Contents for Alienware M17x R4
Page 43: ...Removing the Center Control Cover 43 1 media control keys cable 1...
Page 59: ...Removing the Display Assembly 59 1 display assembly 2 screws 6 1 2...
Page 68: ...68 Removing the Bluetooth Card 1 Bluetooth card cable 2 Bluetooth card 3 screw 1 3 2...
Page 71: ...Removing the Speakers 71 1 speakers 2 2 screws 4 3 speakers cable 1 2 3...
