■
appendix B agency regulatory notices
B-3
Community.
Compliance with these directives implies conformity to the following
European Norms:
n
EN55022 (CISPR 22) Radio Frequency Interference
n
EN50082 (IEC801-2, IEC801-3, IEC801-4) Electro-magnetic
Immunity
n
EN 300 328-2 (ETS 300 328) Radio Spectrum Matter.
n
TBR21 (ETS TBR21) Terminal Equipment.
n
EN60950 (IEC950) I.T.E. Product Safety
Canadian Notice
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications.
Le present appareil numerique nemet pas de bruits radioelectriques
depassant les limites applicables aux appareils numeriques de Classe B
prescrites dans le reglement sur le brouillage radioelectrique edicte par le
Ministere des Communications du Canada.
Power Cord Requirement
The power cord supplied with the AC adapter should match the plug and
voltage requirements for your local area. Regulatory approval for the AC
adapter has been obtained using the power cord for the local area.
However, if you travel to a different area and need to connect to a different
outlet or voltage, you should use one of the power cords listed below. To
purchase a power cord (including one for a country not listed below) or a
replacement ac adapter, contact your local dealer.
U.S. and Canada
n
The cord set must be UL-Listed and CSA-Certified or C-UL Listed.
n
The minimum specifications for the flexible cord are (1) No. 18 AWG,
(2) Type SJ, and (3) 3-conductor.
n
The cord set must have a rated current capacity of at least 10 A.
n
The attachment plug must be an earth-grounding type with a NEMA
5-15P (15A, 125V) or NEMA 6-15P (15 A, 250V) configuration.
Japan
n
All components of the cord set (cord, connector, and plug) must bear
a `PSE` mark and registration number in accordance with the
